* [edk2-platforms][PATCH v2 0/1] Platform/RaspberryPi/Drivers: Add SD card detection
@ 2020-07-10 9:43 Pete Batard
2020-07-10 9:43 ` [edk2-platforms][PATCH v2 1/1] " Pete Batard
0 siblings, 1 reply; 2+ messages in thread
From: Pete Batard @ 2020-07-10 9:43 UTC (permalink / raw)
To: devel; +Cc: ard.biesheuvel, leif, awarkentin
v2 to correct a couple "STATIC" -> "static" that were applied by
an overzealous text editor.
No other changes from v1.
Pete Batard (1):
Platform/RaspberryPi/Drivers: Add SD card detection
Platform/RaspberryPi/Drivers/ArasanMmcHostDxe/ArasanMmcHostDxe.c | 66 +++++++++++++++++---
Platform/RaspberryPi/Drivers/SdHostDxe/SdHostDxe.c | 65 ++++++++++++++++---
Platform/RaspberryPi/Include/Protocol/RpiMmcHost.h | 6 ++
3 files changed, 120 insertions(+), 17 deletions(-)
--
2.21.0.windows.1
^ permalink raw reply [flat|nested] 2+ messages in thread
* [edk2-platforms][PATCH v2 1/1] Platform/RaspberryPi/Drivers: Add SD card detection
2020-07-10 9:43 [edk2-platforms][PATCH v2 0/1] Platform/RaspberryPi/Drivers: Add SD card detection Pete Batard
@ 2020-07-10 9:43 ` Pete Batard
0 siblings, 0 replies; 2+ messages in thread
From: Pete Batard @ 2020-07-10 9:43 UTC (permalink / raw)
To: devel; +Cc: ard.biesheuvel, leif, awarkentin, Andrei Warkentin
The Raspberry Pi 3 and Pi 4 platforms (with latest EEPROM) can boot
straight from USB, without the need for an SD card being present.
However, the IsCardPresent () calls from the ArasanMmcHost and SdHost
drivers are currently hardwired to return TRUE, which results in
straight to USB boot failing due to the SD drivers looping on
errors while trying to poke at a non-existent card...
Ideally, we would use the Card Detect signal from the uSD slot, to
report on the presence or absence of a card, but the Raspberry Pi
Foundation did not wire those signals in the Pi 2 and subsequent
models, leaving us with only potentially interfering SD commands
as means to perform card detection.
As a result of this, we are left with no other choice but limit
detection to occurring only once, prior to formal SD card init,
and then return the detected value for subsequent calls. This,
however, is more than good enough for the intended purpose, which
is to allow straight to USB boot.
Tested on Raspberry Pi 3 and 4, and for both SD controllers.
Addresses pftf/RPi3#13, pftf/RPi3#14, pftf/RPi4#37.
Signed-off-by: Pete Batard <pete@akeo.ie>
Reviewed-by: Andrei Warkentin <andrey.warkentin@gmail.com>
Tested-by: Andrei Warkentin <andrey.warkentin@gmail.com>
---
Platform/RaspberryPi/Drivers/ArasanMmcHostDxe/ArasanMmcHostDxe.c | 66 +++++++++++++++++---
Platform/RaspberryPi/Drivers/SdHostDxe/SdHostDxe.c | 65 ++++++++++++++++---
Platform/RaspberryPi/Include/Protocol/RpiMmcHost.h | 6 ++
3 files changed, 120 insertions(+), 17 deletions(-)
diff --git a/Platform/RaspberryPi/Drivers/ArasanMmcHostDxe/ArasanMmcHostDxe.c b/Platform/RaspberryPi/Drivers/ArasanMmcHostDxe/ArasanMmcHostDxe.c
index 6d706af6f276..08e5be1f015f 100644
--- a/Platform/RaspberryPi/Drivers/ArasanMmcHostDxe/ArasanMmcHostDxe.c
+++ b/Platform/RaspberryPi/Drivers/ArasanMmcHostDxe/ArasanMmcHostDxe.c
@@ -11,7 +11,8 @@
#define DEBUG_MMCHOST_SD DEBUG_VERBOSE
-BOOLEAN PreviousIsCardPresent = FALSE;
+BOOLEAN CardIsPresent = FALSE;
+CARD_DETECT_STATE CardDetectState = CardDetectRequired;
UINT32 LastExecutedCommand = (UINT32) -1;
STATIC RASPBERRY_PI_FIRMWARE_PROTOCOL *mFwProtocol;
@@ -239,14 +240,6 @@ CalculateClockFrequencyDivisor (
return EFI_SUCCESS;
}
-BOOLEAN
-MMCIsCardPresent (
- IN EFI_MMC_HOST_PROTOCOL *This
-)
-{
- return TRUE;
-}
-
BOOLEAN
MMCIsReadOnly (
IN EFI_MMC_HOST_PROTOCOL *This
@@ -418,6 +411,10 @@ MMCNotifyState (
DEBUG ((DEBUG_MMCHOST_SD, "ArasanMMCHost: MMCNotifyState(State: %d)\n", State));
+ // Stall all operations except init until card detection has occurred.
+ if (State != MmcHwInitializationState && CardDetectState != CardDetectCompleted)
+ return EFI_NOT_READY;
+
switch (State) {
case MmcHwInitializationState:
{
@@ -489,6 +486,57 @@ MMCNotifyState (
return EFI_SUCCESS;
}
+BOOLEAN
+MMCIsCardPresent (
+ IN EFI_MMC_HOST_PROTOCOL *This
+)
+{
+ EFI_STATUS Status;
+
+ //
+ // If we are already in progress (we may get concurrent calls)
+ // or completed the detection, just return the current value.
+ //
+ if (CardDetectState != CardDetectRequired)
+ return CardIsPresent;
+
+ CardDetectState = CardDetectInProgress;
+ CardIsPresent = FALSE;
+
+ //
+ // The two following commands should succeed even if no card is present.
+ //
+ Status = MMCNotifyState (This, MmcHwInitializationState);
+ if (EFI_ERROR (Status)) {
+ DEBUG ((DEBUG_ERROR, "MMCIsCardPresent: Error MmcHwInitializationState, Status=%r.\n", Status));
+ // If we failed init, go back to requiring card detection
+ CardDetectState = CardDetectRequired;
+ return FALSE;
+ }
+
+ Status = MMCSendCommand (This, MMC_CMD0, 0);
+ if (EFI_ERROR (Status)) {
+ DEBUG ((DEBUG_ERROR, "MMCIsCardPresent: CMD0 Error, Status=%r.\n", Status));
+ goto out;
+ }
+
+ //
+ // CMD8 should tell us if a card is present.
+ //
+ Status = MMCSendCommand (This, MMC_CMD8, CMD8_SD_ARG);
+ if (EFI_ERROR (Status)) {
+ DEBUG ((DEBUG_INFO, "MMCIsCardPresent: No card detected, Status=%r.\n", Status));
+ goto out;
+ }
+
+ DEBUG ((DEBUG_INFO, "MMCIsCardPresent: Card detected.\n"));
+ CardIsPresent = TRUE;
+
+out:
+ CardDetectState = CardDetectCompleted;
+ return CardIsPresent;
+}
+
EFI_STATUS
MMCReceiveResponse (
IN EFI_MMC_HOST_PROTOCOL *This,
diff --git a/Platform/RaspberryPi/Drivers/SdHostDxe/SdHostDxe.c b/Platform/RaspberryPi/Drivers/SdHostDxe/SdHostDxe.c
index 2f31c5eb8c46..964b2d3ac5c1 100644
--- a/Platform/RaspberryPi/Drivers/SdHostDxe/SdHostDxe.c
+++ b/Platform/RaspberryPi/Drivers/SdHostDxe/SdHostDxe.c
@@ -64,6 +64,8 @@ STATIC CONST CHAR8 *mFsmState[] = { "identmode", "datamode", "readdata",
"genpulses", "writewait2", "?",
"startpowdown" };
#endif /* NDEBUG */
+STATIC BOOLEAN CardIsPresent = FALSE;
+STATIC CARD_DETECT_STATE CardDetectState = CardDetectRequired;
STATIC UINT32 mLastGoodCmd = MMC_GET_INDX (MMC_CMD0);
STATIC inline BOOLEAN
@@ -264,14 +266,6 @@ SdHostSetClockFrequency (
return Status;
}
-STATIC BOOLEAN
-SdIsCardPresent (
- IN EFI_MMC_HOST_PROTOCOL *This
- )
-{
- return TRUE;
-}
-
STATIC BOOLEAN
SdIsReadOnly (
IN EFI_MMC_HOST_PROTOCOL *This
@@ -639,6 +633,10 @@ SdNotifyState (
{
DEBUG ((DEBUG_MMCHOST_SD, "SdHost: SdNotifyState(State: %d) ", State));
+ // Stall all operations except init until card detection has occurred.
+ if (State != MmcHwInitializationState && CardDetectState != CardDetectCompleted)
+ return EFI_NOT_READY;
+
switch (State) {
case MmcHwInitializationState:
DEBUG ((DEBUG_MMCHOST_SD, "MmcHwInitializationState\n", State));
@@ -718,6 +716,57 @@ SdNotifyState (
return EFI_SUCCESS;
}
+STATIC BOOLEAN
+SdIsCardPresent (
+ IN EFI_MMC_HOST_PROTOCOL *This
+ )
+{
+ EFI_STATUS Status;
+
+ //
+ // If we are already in progress (we may get concurrent calls)
+ // or completed the detection, just return the current value.
+ //
+ if (CardDetectState != CardDetectRequired)
+ return CardIsPresent;
+
+ CardDetectState = CardDetectInProgress;
+ CardIsPresent = FALSE;
+
+ //
+ // The two following commands should succeed even if no card is present.
+ //
+ Status = SdNotifyState (This, MmcHwInitializationState);
+ if (EFI_ERROR (Status)) {
+ DEBUG ((DEBUG_ERROR, "SdIsCardPresent: Error MmcHwInitializationState, Status=%r.\n", Status));
+ // If we failed init, go back to requiring card detection
+ CardDetectState = CardDetectRequired;
+ return FALSE;
+ }
+
+ Status = SdSendCommand (This, MMC_CMD0, 0);
+ if (EFI_ERROR (Status)) {
+ DEBUG ((DEBUG_ERROR, "SdIsCardPresent: CMD0 Error, Status=%r.\n", Status));
+ goto out;
+ }
+
+ //
+ // CMD8 should tell us if a card is present.
+ //
+ Status = SdSendCommand (This, MMC_CMD8, CMD8_SD_ARG);
+ if (EFI_ERROR (Status)) {
+ DEBUG ((DEBUG_INFO, "SdIsCardPresent: No card detected, Status=%r.\n", Status));
+ goto out;
+ }
+
+ DEBUG ((DEBUG_INFO, "SdIsCardPresent: Card detected.\n"));
+ CardIsPresent = TRUE;
+
+out:
+ CardDetectState = CardDetectCompleted;
+ return CardIsPresent;
+}
+
BOOLEAN
SdIsMultiBlock (
IN EFI_MMC_HOST_PROTOCOL *This
diff --git a/Platform/RaspberryPi/Include/Protocol/RpiMmcHost.h b/Platform/RaspberryPi/Include/Protocol/RpiMmcHost.h
index c558e00bf500..78514a31bc4e 100644
--- a/Platform/RaspberryPi/Include/Protocol/RpiMmcHost.h
+++ b/Platform/RaspberryPi/Include/Protocol/RpiMmcHost.h
@@ -82,6 +82,12 @@ typedef enum _MMC_STATE {
MmcDisconnectState,
} MMC_STATE;
+typedef enum _CARD_DETECT_STATE {
+ CardDetectRequired = 0,
+ CardDetectInProgress,
+ CardDetectCompleted
+} CARD_DETECT_STATE;
+
#define EMMCBACKWARD (0)
#define EMMCHS26 (1 << 0) // High-Speed @26MHz at rated device voltages
#define EMMCHS52 (1 << 1) // High-Speed @52MHz at rated device voltages
--
2.21.0.windows.1
^ permalink raw reply related [flat|nested] 2+ messages in thread
end of thread, other threads:[~2020-07-10 9:43 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2020-07-10 9:43 [edk2-platforms][PATCH v2 0/1] Platform/RaspberryPi/Drivers: Add SD card detection Pete Batard
2020-07-10 9:43 ` [edk2-platforms][PATCH v2 1/1] " Pete Batard
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox