Hello all:

In the IPV4 and IPV6 Configuration Page after the changes are applied the system proceed to boot to the boot device and its not staying in same form.

case KEY_SAVE_CHANGES:
      Status = Ip6ConvertIfrNvDataToConfigNvDataGeneral (IfrNvData, Instance);
      if (EFI_ERROR (Status)) {
        break;
      }
      *ActionRequest = EFI_BROWSER_ACTION_REQUEST_SUBMIT;
      *ActionRequest = EFI_BROWSER_ACTION_REQUEST_FORM_APPLY; //Modified code
      break;

If the browser action changed as above the control retained in the same page.

Is there any specific reason after the IP Configuration Settings applied it proceed to Boot?

-Siva

Please consider the environment before printing this email.

The information contained in this message may be confidential and proprietary to American Megatrends (AMI).  This communication is intended to be read only by the individual or entity to whom it is addressed or by their designee. If the reader of this message is not the intended recipient, you are on notice that any distribution of this message, in any form, is strictly prohibited.  Please promptly notify the sender by reply e-mail or by telephone at 770-246-8600, and then delete or destroy all copies of the transmission.